Security Link SL150 Guía para resolver problemas descargar pdf (Pagina 52)

SL150 Installation and Setup Guide

8–4

Programming the 4285/4286 VIP Module

You must program the system for use with the 4285 or 4286 VIP Module. This includes

assigning a phone code and selecting words from the alpha vocabulary. Refer to the

programming sections for specific programming details.

Checking 4285/4286 VIP Module Operation

To Check Operation From an On-Premises Phone:

1. Pick up the phone and enter the programmed 2-digit phone code. Annunciation of a

system status report should automatically start. See the User’s Guide accompanying the

phone module for detailed information regarding the nature of the status report, if

necessary.

2. During any pause in the status report, or immediately following it, key the following via

the keypad on the phone:

4112 (Installer code) + 1 (OFF).

You should hear a beep on the phone and from a wired keypad. You should also hear the

words, "System Ready" or "Not Ready, press star to show faults"* indicating that the

command was entered successfully.

* This voice message would indicate an open zone.

3. Hang up the phone.

To Check Operation from an Off-Premises Phone:

1. Have someone dial the premises phone number, using a TouchTone phone.

• If the phone system does not include an answering machine, 2 long tones will be heard

in the caller’s phone, followed by a voice prompt "Hello, Enter Phone Code Now."

The caller should enter the programmed 2-digit phone code.

• If the premises phone system includes an answering machine, the 2-digit phone code

should be entered during a pause at the beginning of, or during, the outgoing

answering machine message. When the 2-digit phone code is entered, the caller will

hear a voice prompt asking for entry of the 4-digit system code ("Enter System Code

Now").

2. The caller should then enter the installer code (4112). As a safety feature, there is a 3-try

limit in which to enter each code (phone code and system code), after which the call-in will

be aborted. Also, if no keys are pressed for a period of 20 seconds, the call-in is aborted.

Annunciation of a system status report will start if both codes were entered correctly.

3. During any pause in the status report, or immediately following it, the caller should key

the following via the keypad on the phone:

4112 (Installer code) + 1 (OFF).

The caller should hear a beep from the phone and a wired keypad on the premises. The

caller should also hear the words "System Ready" or "Not Ready, press star to show

faults"* * on the phone, indicating that the command was entered successfully.

This voice message would indicate an open zone

4. At this point, the caller can hang up the phone.

5. Verify with the caller that there was successful access to the system and that the

appropriate annunciations were heard over the phone.

6. If the phone module functioned satisfactorily, unplug the AC transformer from the AC

outlet.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 143 144

Comentarios a estos manuales

Sin comentarios

Security Link SL150 Guía para resolver problemas Pagina 52

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Security Link SL150