
SL150 Installation and Setup Guide
15–10
✱
84 PAGER REPORTS 0
0
0 = No reports sent Pgr 1 Pgr 2
1 = Open/close for all users
3 =
Open/close for
users
5-16 and wireless key zones entered in zone list 6/7
*
4 = All alarms and troubles
5 = All alarms, troubles, and open/close for all users
7 = All alarms, troubles, and open/close for users 5-16, and wireless key
zones entered in zone list 6/7
*
12 = Alarms and
troubles
for zones entered in zone list 6/7
*
13 = Alarms and
troubles
for zones listed in zone list 6/7
*
,
open/close for all users
15 = All alarms and troubles for zones entered in zone list 6, open/close for
users 5-16, and wireless key zones entered in zone list 6/7
*,
users
5-16,
and wireless key zones entered in zone list 6/7
*
*
Zone List 6 for Pager 1, Zone List 7 for Pager 2
.
✱
85 PAGER #1 PHONE NO.
| | | | | | | | | | | | | | | | | | |
Enter up to 20 digits. If you enter fewer than 20 digits, exit by pressing [
✱
]
and next field number. To clear entries from this field, press
✱
85
✱
.
✱
86 PAGER #1 CHARACTERS
| | | | | | | | | | | | | | |
Up to 16 characters may be sent as a prefix to the 7-digit system status code
sent to pager #1 (if used). Phone number in field
✱85 must have been
entered. If fewer than 16 characters, exit by pressing [
✱]
and next field
number.
To clear entries from this field, press
✱
86
✱
.
For example, these optional 16 characters may be composed of the following:
•
PIN number (to identify a specific pager to the paging company)
•
Subscriber account number
•
✱
(enter # + 11 to
send
✱
)
•
# (enter # + 12 to
send
#
)
•
Pause (enter # + 13 to allow a 2-second pause)
*
•
Any special character(s) the end user may decide to transmit
*
Note that some paging systems require pause(s) at the beginning of the prefix.
The format for the 7-digit system status code is defined as follows:
Pager Format: XXX-YYYY
where:
XXX = 3-digit event code: 911 = Alarm 101 = Opening (disarm)
811 = Trouble 102 = Closing (arm AWAY)
YYYY = 4-digit user or zone number (depending on type of event).
The first two digits must always be 00, and must be followed by the 2-digit
user or zone number.
Comentarios a estos manuales